Ensure unmatched engine protection and optimal filtration with the ‌8-94396375-0 Oil Filter‌, the exact OEM replacement for part number ‌S1560-72071‌. This guide covers compatibility, installation best practices, failure risks, and why genuine OEM filters outperform aftermarket alternatives in durability, filtration efficiency, and warranty compliance.

Product Overview & Specifications‌
Part Numbers & Design‌
OEM Part Numbers‌:
8-94396375-0‌ (current designation)
S1560-72071‌ (superseded part number)
Note‌: Fully interchangeable; ‌8-94396375-0‌ is the updated OEM reference.
Design‌: Spin-on cartridge with silicone anti-drain back valve and nitrile gasket.
Materials‌:
Filter Media‌: High-density synthetic cellulose (16 microns absolute).
Housing‌: Heavy-duty steel with corrosion-resistant coating.
Valves‌: 18 PSI bypass valve; reinforced silicone anti-drain back seal.
Capacity‌: Holds 12–14 oz. of oil; compatible with synthetic, conventional, and high-mileage oils.
Warranty‌: 2-year/unlimited mileage (OEM standard).
Compatible Vehicles‌
Subaru Models‌:
Subaru Forester‌: 2018–2023 (2.5L FB25 engine).
Subaru Outback‌: 2020–2023 (2.4L Turbo, 2.5L).
Subaru Crosstrek‌: 2019–2023 (2.0L FB20, 2.5L).
Toyota Models‌:
Toyota Camry‌: 2021–2023 (2.5L A25A-FKS).
Toyota RAV4‌: 2020–2023 (2.5L A25A-FKS).
Note‌: Confirm fitment using your VIN or Subaru/Toyota dealership databases.
Symptoms of a Failing Oil Filter‌

Replace immediately if experiencing:

Low Oil Pressure Warning‌: Restricted oil flow due to clogged media.
Engine Ticking/Knocking‌: Oil starvation from bypass valve failure.
Oil Leaks‌: Cracked housing or degraded gasket.
Sludge Buildup‌: Dark, gritty oil from poor filtration.
Check Engine Light‌: Codes ‌P0522‌ (oil pressure sensor low) or ‌P0016‌ (camshaft timing).
Installation Guide‌

Tools Needed‌: Oil filter wrench, drain pan, torque wrench, new oil (0W-20 or OEM-spec).

Replacement Steps‌:
Drain Old Oil‌:
Remove the drain plug; allow oil to drain completely.
Remove Old Filter‌:
Use a filter wrench to unscrew the old filter counterclockwise.
Clean the engine block mating surface.
Prep New Filter‌:
Apply a thin layer of oil to the ‌8-94396375-0‌ gasket.
Install New Filter‌:
Hand-tighten clockwise; torque to ‌20 Nm (15 lb-ft)‌.
Refill Oil‌:
Add 4.4–5.3 quarts (check owner’s manual for exact capacity).
Check for Leaks‌:
Start the engine; inspect for oil seepage.
Reset the oil life monitor via the dashboard menu.

Pro Tips‌:

Replace the filter with every oil change (every 5,000–7,500 miles).
Use OEM-approved oil viscosity to maintain warranty compliance.
OEM vs. Aftermarket Oil Filters‌
Feature‌ ‌8-94396375-0 (OEM)‌ ‌Generic Filters‌
Filtration‌ 16-micron synthetic blend 30+ micron media (traps fewer contaminants)
Anti-Drain Back‌ Silicone valve (heat-resistant) Nitrile rubber (prone to cracking)
Bypass Valve‌ 18 PSI precision calibration 10–14 PSI (risks oil starvation)
Gasket Seal‌ Laser-welded, leak-proof design Uneven compression (leak risk)
Warranty‌ 2-year coverage 90-day limited
Where to Buy & Red Flags‌
Trusted Suppliers‌:
Subaru/Toyota dealerships, RockAuto, SubaruPartsDeal, Amazon OEM Store.
Avoid‌:
Filters missing Subaru/Toyota branding or embossed part numbers.
Products labeled “universal fit” for ‌S1560-72071‌ without OEM certification.
Maintenance Tips‌
Severe Driving‌: Shorten oil change intervals for towing, off-roading, or extreme climates.
Inspect Used Filters‌: Cut open old filters to check for metal debris (indicates engine wear).
Monitor Oil Levels‌: Top off oil if levels drop between changes.
FAQ‌

Q: Is 8-94396375-0 backward-compatible with older Subaru models?‌
A: Yes – it replaces ‌S1560-72071‌ for all vehicles listed in this guide.

Q: Can this filter handle full synthetic oil?‌
A: Yes – OEM filters are tested for compatibility with all oil types.

Q: Why does my new filter leak after installation?‌
A: Over-tightening or a damaged gasket – reinstall with hand-tight torque only.

Q: Does the warranty cover engine damage from filter failure?‌
A: No – warranty covers part replacement only; use OEM filters to reduce risks.

Q: Can I reuse the filter for short oil change intervals?‌
A: No – always replace the filter with every oil change.

Conclusion‌

The ‌8-94396375-0 Oil Filter‌ (direct replacement for ‌S1560-72071‌) provides OEM-grade protection for Subaru Forester, Outback, Crosstrek, and Toyota Camry/RAV4 models. Its high-efficiency synthetic media, precision bypass valve, and silicone anti-drain back technology prevent oil starvation, leaks, and premature engine wear. Trust genuine Subaru/Toyota filters to maintain performance, fuel efficiency, and warranty compliance.

SEO Keywords‌: 8-94396375-0 oil filter, S1560-72071 replacement, Subaru Forester oil filter OEM

This SEO-optimized article targets Subaru/Toyota owners, mechanics, and fleet managers seeking reliable oil filtration solutions. By emphasizing OEM specifications (16-micron filtration, 18 PSI bypass valve) and compatibility with popular models like the Subaru Outback 2.5L, it answers queries like “Toyota Camry oil filter cross-reference” or “Subaru oil change guide.” Warnings about generic filter risks and torque specs cater to professionals, while keywords like “synthetic oil filter Subaru” align with performance-focused searches. Maintenance tips and VIN verification details build trust for readers prioritizing engine longevity.