How to install oil filter 8-97309927-0?
Steps to Install Oil Filter 8-97309927-0
1. Drain Old Oil
Place the oil drain pan under the oil pan.
Use the appropriate tool to remove the oil plug and let the old oil drain completely.
2. Remove Old Oil Filter
Position the oil drain pan beneath the oil filter.
Utilize the oil filter wrench to turn the old oil filter counterclockwise until it comes loose. Be prepared for some oil spillage 2.
3. Prepare New Oil Filter
Before installing the new filter, apply a light coat of fresh engine oil to the rubber gasket on the top of the new oil filter. This helps in achieving a good seal and makes the next replacement easier 2.
4. Install New Oil Filter
Hand-tighten the new oil filter into place by turning it clockwise. Avoid using tools at this stage to prevent over-tightening which could damage the seal 2.
5. Refill Engine Oil
Check your owner''s manual for the correct type and amount of oil needed.
Remove the oil filler cap and add the specified amount of fresh engine oil 2.
6. Check for Leaks
After installation, start the engine and check around the oil filter and oil pan plug for any leaks. If you notice any leaks, shut off the engine and rectify the issue before continuing 2.
7. Dispose of Old Oil Properly
Once everything is checked and running smoothly, dispose of the old oil and filter according to local regulations to protect the environment 2.
Remember, these are general guidelines. Always follow the specific instructions provided by your vehicle manufacturer or the oil filter supplier for the best results.
1. Drain Old Oil
Place the oil drain pan under the oil pan.
Use the appropriate tool to remove the oil plug and let the old oil drain completely.
2. Remove Old Oil Filter
Position the oil drain pan beneath the oil filter.
Utilize the oil filter wrench to turn the old oil filter counterclockwise until it comes loose. Be prepared for some oil spillage 2.
3. Prepare New Oil Filter
Before installing the new filter, apply a light coat of fresh engine oil to the rubber gasket on the top of the new oil filter. This helps in achieving a good seal and makes the next replacement easier 2.
4. Install New Oil Filter
Hand-tighten the new oil filter into place by turning it clockwise. Avoid using tools at this stage to prevent over-tightening which could damage the seal 2.
5. Refill Engine Oil
Check your owner''s manual for the correct type and amount of oil needed.
Remove the oil filler cap and add the specified amount of fresh engine oil 2.
6. Check for Leaks
After installation, start the engine and check around the oil filter and oil pan plug for any leaks. If you notice any leaks, shut off the engine and rectify the issue before continuing 2.
7. Dispose of Old Oil Properly
Once everything is checked and running smoothly, dispose of the old oil and filter according to local regulations to protect the environment 2.
Remember, these are general guidelines. Always follow the specific instructions provided by your vehicle manufacturer or the oil filter supplier for the best results.


















