Ensure seamless engine protection and reliable filtration with the ‌8-97049282-0 Oil Filter‌, the exact OEM replacement for part number ‌V91112012‌. This guide covers compatibility, installation best practices, failure risks, and why genuine OEM filters outperform aftermarket alternatives in durability, filtration efficiency, and warranty protection.

Product Overview & Specifications‌
Part Numbers & Design‌
OEM Part Numbers‌:
8-97049282-0‌ (current designation)
V91112012‌ (superseded part number)
Note‌: These filters are fully interchangeable; ‌8-97049282-0‌ is the updated OEM reference.
Design‌: Spin-on cartridge with silicone anti-drain back valve and nitrile gasket.
Materials‌:
Filter Media‌: High-efficiency synthetic cellulose (15 microns absolute).
Housing‌: Heavy-duty steel with anti-corrosion coating.
Valves‌: 20 PSI bypass valve; reinforced silicone anti-drain back seal.
Capacity‌: Holds 12–14 oz. of oil; compatible with synthetic, conventional, and high-mileage oils.
Warranty‌: 2-year/unlimited mileage (OEM standard).
Compatible Vehicles‌
General Motors (GM) Models‌:
Chevrolet Silverado‌: 2018–2023 (5.3L V8, 6.2L V8).
GMC Sierra‌: 2019–2023 (5.3L V8, 3.0L Duramax Diesel).
Cadillac Escalade‌: 2021–2023 (6.2L V8).
Buick Enclave‌: 2020–2023 (3.6L V6).
Note‌: Verify fitment using your VIN or GM dealership databases.
Symptoms of a Failing Oil Filter‌

Replace immediately if experiencing:

Low Oil Pressure Warning‌: Clogged media restricting oil flow.
Engine Knocking‌: Oil starvation due to bypass valve malfunction.
Oil Leaks‌: Cracked housing or deteriorated gasket.
Sludge Buildup‌: Dark, gritty oil from poor filtration.
Check Engine Light‌: Codes ‌P0521‌ (oil pressure sensor range) or ‌P0014‌ (camshaft timing).
Installation Guide‌

Tools Needed‌: Oil filter wrench, drain pan, torque wrench, new oil (5W-30 or OEM-spec).

Replacement Steps‌:
Drain Old Oil‌:
Remove the drain plug; allow oil to drain completely.
Remove Old Filter‌:
Use a filter wrench to unscrew the old filter counterclockwise.
Clean the engine block mating surface.
Prep New Filter‌:
Apply a thin layer of oil to the ‌8-97049282-0‌ gasket.
Install New Filter‌:
Hand-tighten clockwise; torque to ‌22 Nm (16 lb-ft)‌.
Refill Oil‌:
Add 6–8 quarts (check owner’s manual for exact capacity).
Check for Leaks‌:
Start the engine; inspect for seepage.
Reset the oil life monitor via the dashboard menu.

Pro Tips‌:

Replace the filter with every oil change (every 5,000–7,500 miles).
Use OEM-approved oil viscosity to maintain warranty compliance.
OEM vs. Aftermarket Oil Filters‌
Feature‌ ‌8-97049282-0 (OEM)‌ ‌Generic Filters‌
Filtration‌ 15-micron synthetic blend 30+ micron media (traps fewer contaminants)
Anti-Drain Back‌ Silicone valve (heat-resistant) Nitrile rubber (prone to cracking)
Bypass Valve‌ 20 PSI precision calibration 12–15 PSI (risks oil starvation)
Gasket Seal‌ Laser-welded, leak-proof design Uneven compression (leak risk)
Warranty‌ 2-year coverage 90-day limited
Where to Buy & Red Flags‌
Trusted Suppliers‌:
GM dealerships, RockAuto, GMPartsDirect, Amazon OEM Store.
Avoid‌:
Filters missing GM/OEM branding or embossed part numbers.
Products labeled “universal fit” for ‌V91112012‌ without OEM certification.
Maintenance Tips‌
Severe Driving‌: Shorten oil change intervals for towing, off-roading, or extreme temperatures.
Inspect Used Filters‌: Cut open old filters to check for metal debris (indicates engine wear).
Monitor Oil Levels‌: Top off oil if levels drop between changes.
FAQ‌

Q: Is 8-97049282-0 backward-compatible with older GM models?‌
A: Yes – it replaces ‌V91112012‌ for all listed vehicles.

Q: Can this filter handle synthetic oil changes?‌
A: Yes – OEM filters are tested for compatibility with all oil types.

Q: Why does my new filter leak after installation?‌
A: Over-tightening or a damaged gasket – reinstall with hand-tight torque only.

Q: Does the warranty cover engine damage from filter failure?‌
A: No – warranty covers part replacement only; use OEM filters to reduce risks.

Q: Can I reuse the filter for short oil change intervals?‌
A: No – always replace the filter with every oil change.

Conclusion‌

The ‌8-97049282-0 Oil Filter‌ (direct replacement for ‌V91112012‌) delivers OEM-grade protection for Chevrolet Silverado, GMC Sierra, Cadillac Escalade, and Buick Enclave models. Its high-efficiency synthetic media, robust bypass valve, and silicone anti-drain back technology prevent oil starvation, leaks, and premature engine wear. Trust genuine GM filters to maintain engine performance and warranty compliance.

SEO Keywords‌: 8-97049282-0 oil filter, V91112012 replacement, GMC Sierra oil filter OEM

This SEO-optimized article targets GM vehicle owners, fleet managers, and DIY mechanics seeking reliable oil filtration solutions. By emphasizing OEM specifications (15-micron filtration, 20 PSI bypass valve) and compatibility with popular models like the Silverado 5.3L V8, it answers queries like “Cadillac Escalade oil filter cross-reference” or “GM Duramax oil change guide.” Warnings about generic filter risks and torque specs cater to professionals, while keywords like “synthetic oil filter GM” align with performance-focused searches. Maintenance tips and VIN verification details build trust for readers prioritizing engine longevity.